Rectangular luminaire housing with integral fitter is extruded aluminum with no visible welds. Frameless tempered glass lens with decorative masking is hinged and secured in place with a single stainless steel quarter-turn fastener for tool-less access to the optical compartment. Lens seals to the housing with one-piece silicone gasketing when closed. Housing is fitted with stainless steel weather-tight strain relief bushing for the power cable exiting the rear of the housing. Luminaire mounts to tenon on pole and secured with four socket head cap screws on top of the housing. Luminaire is available in single or twin back-to-back mounting configurations. All hardware is stainless steel.
Optics include 2 individual LED modules. Each module consists of an aluminum core PCB with fourteen high-power LEDs and a single piece prismatic lens molded from optical quality acrylic. The prismatic lens redirects light output from the individual LEDs and is available in two distributions as a Type II (S optics) or Type III distribution (ME optics). Luminaire emits zero uplight at 90 degrees horizontal and above and is suitable for use in all LEED lighting zones. LED circuit boards are equipped with electrical disconnects to allow for future technology upgrades.
Type II: B1-U0-G1
Type III: B1-U0-G1
LED DELIVERED LUMEN OUTPUT
3000K - Type II = 3332 lumens / Type III = 3323 lumens
4000K - Type II = 3793 lumens / Type III = 3788 lumens
NOTE : Due to rapid and continuous advances in LED technology, LED luminaire data is subject to change without notice and at the discretion of HessAmerica. Consult factory for current technical data.
Electronic LED driver supplies 500mA drive current to LED modules with input voltage range from 120v to 277v at 50/60Hz. Power consumption is 50 watts.
LUMINAIRE WEIGHT: 22 lbs
LUMINAIRE EPA: 1.3 sq. ft
Straight rectangular pole is 6.3" x 3.9" nominal and manufactured from seamless 6061 aluminum tubing and heat treated to produce a T6 temper. Nominal wall thickness is 0.236". Sides of the shaft are flat with 1/8" radiussed corners. Flush mounted hand hole cover is plasma cut with kerf not to exceed 1/8'' and includes triangular tamper-resistant locking device. Two piece base cover is fabricated aluminum. Nominal pole height is 15'.
Straight rectangular pole is 6.3" x 3.5" nominal and manufactured from cold drawn over mandrel, electric weld, mechanical steel tubing with nominal wall thickness of 0.197". Sides of shaft are flat with 1/2" radiussed corners. Pole shall show no seam along the shaft. Flush mounted hand hole cover is plasma cut with kerf not to exceed 1/8" and includes triangular tamper-resistant locking device. Pole is hot-dip galvanized with coating inside and out, then lightly sanded prior to painting. Two piece base cover is fabricated aluminum. Nominal pole height is 15'.
Standard finish is finely textured matte silver grey metallic or graphite grey. Special colors available on request.
CERTIFICATION: CSA Certified for Wet Locations
INGRESS PROTECTION: IP65
Limited product warranty period including LEDs is five years. Driver shall carry the manufacturer's limited warranty.